cylinder block的例句大全

Position the cylinder heads onto head gaskets and cylinder block.

将汽缸盖安置到汽缸盖罩垫和汽缸体上.

互联网摘选

HINT: Keep the upper bearing and upper thrust washers together with the cylinder block.

提示: 请上轴承和止推垫圈上与缸体.

互联网摘选

The casting reject ratio of cylinder block caused by crankcase core is controlled below 0.25 % at present.

目前,我厂在气缸体的生产中,由于曲轴箱壳芯原因造成的缸体铸件废品可控制在0.25%以内.

互联网摘选

Tighten the radiator drain cock and ( if removed ), the cylinder block drain-plug.

旋紧散热器排放口和汽缸体排放塞 ( 如果它被卸去了 ).

互联网摘选

Like the cylinder block, the head is made from either cast iron or aluminum alloy.

像气缸体一样, 气缸盖是由铸铁或者铝合金制成.

互联网摘选

The principles to construct finite element model modal analysis of the cylinder block have been obtained.

通过研究,得出了建立内燃机机体的有限元模型的一些原则.

互联网摘选

Relative to the metal roller and plate cylinder, block drum and nano-imprint lithography drum case might.

不绝对于金属网纹辊与印版滚筒 、 印版滚筒与压印滚筒的不张辛而言可以不详不小些.

互联网摘选

The model was employed to evaluate the equipment usability of an engine cylinder block production line.

并利用该模型研究了发动机缸体生产线设备可用性的评价问题.

互联网摘选

Dispersed shrinkage is the main reason causing leakage of cylinder block of 4 DA 1.

缩松缺陷是导致4DA1型发动机气缸体螺栓孔渗漏的主要原因.

互联网摘选

Remove the water pump from cylinder block.

从汽缸体上拆去水泵.

互联网摘选

The reasons causing leakage of cylinder block and head were analyzed.

分析引起缸体、缸盖渗漏的原因.

互联网摘选

The crankcase is the lower part of the engine cylinder block.

曲轴箱是发动机气缸体较低的部分.

词典精选例句

The features of cylinder block and cylinder head core assembly vertical casting process are introduced.

介绍了缸体、缸盖组芯立浇工艺的特点.

互联网摘选

The cylinder head is attached to the block with high-tensile steel studs.

气缸盖与气缸体用高强度的钢螺栓缚连结.

互联网摘选

The elevation and fall of the load is controlled by a cylinder driven pulley block.

负载的升降是通过气缸驱动滑轮组实现.

网络文摘精选

Adding balance weights can effectively eliminate the cylinder block cracking.

加平衡块后，可以有效地解决缸体裂纹问题。

互联网摘选

Production Practice to Improve Machinability of Bottom Cylinder Block

改善发动机下气缸体加工性能的生产实践

互联网摘选

Study on Measure for Steam Cylinder Shim Block of Positional Tolerance and Wire Profile Tolerance

汽缸垫片位置度与线轮廓度测量研究

互联网摘选